Distance spacer 20mm for worksurface

The Spacer Cap 20mm for Work Surface is a spacing component for suitable fully automatic eyelet machine configurations. The 20mm version is used when positioning the corresponding length stop.

The component supports a fixed distance setting during material positioning.

Applications

This spacer cap is used when processing banners, tarpaulins and technical textile products where a consistent distance from the stop is required.

What should you consider?

Check that the 20mm spacer cap is suitable for the stop and machine configuration. The cap size must match the required setting.

Processing and use

Install the spacer cap in its designated position according to the machine instructions. Check that it is securely attached and perform a test installation to verify material positioning.

Matching products

This spacer cap can be combined with suitable length stops and work surface configurations on fully automatic eyelet machines.

Alternative or other version

Spacer caps are available in 10mm, 12mm, 16mm, 20mm (this version), 25mm and 40mm. The correct size depends on the required distance setting.

Matching Fepatex solution

This spacer cap provides a practical solution for setting a consistent material position during eyelet installation.